Need Help?
We've got your back

Step by step instructions to make sure your installation is as easy as possible. Have your LED sign installed fast. You can do this!


Step 1

Using our online design software. Choose from our many modern font options and we'll create and ship your masterpiece.

SHOP NOW

Step 2

Gather supplies: house numbers, template, Threaded rods, (not included: tape, caulk, drill, Measuring tape, Wire Stripper, Cable Ties, Wire Nuts, 18awg wire). Masonry, concrete, and stone installations may require a hammer drill.

Step 3

Twist in the provided threaded rods into the mounted spacers on the back of the letters. Use pliers if needed.

Step 4

Measure and tape template at desired location. Use the guide lines on the template for measurements. DO NOT use the paper edge as a guide line for measurements.

Step 5

Use a 1/4" drill bit for your specific surface. Drill straight holes as close to the middle of your circular drill marks. Drill the black markings with a 3/8" or 1/2" bit for the wires then carefully remove the template.

Step 6

Fish the wires and dry fit your sign into your drilled holes. If the holes are too loose and the letters are not holding. Wrap a small piece of tape around the threaded rod as a temporary shimming.

Step 7

Without pulled the wires out, Using any all purpose outdoor caulk, apply a generous coating to the threaded rods and affix the sign to your installation surface, then fill in the wire hole.

Step 8

Peel the protective layer from the letters.

Step 9

Do the electrical work ensuring to connect the sign to the 12v connection of the included power supply.